Hougen 6-18232 1" X 6" Copperhead Annular Cutter

Your Price: $136.00

Retail Price:$160.00

Your Savings:$24.00(15%)

Hougen 1" X 6" Copperhead Annular Cutter

Part Number: 6-18232

Availability: In Stock Orders $75+ Ship Free

Quantity

Description

Copperhead™ Carbide Tip Cutters

Copperhead Carbide Tip Annular Cutters feature a durable grade carbide

insert for extended tool life when used with Hougen Mag Drills on abrasive

and tough-to-cut materials. The unique Hougen design also includes a special

tool geometry that helps maintain better chip flow than other brands.

Part #: 6-18232

Cutter Diameter: 1"

DOC: 6"

Pilot Pin #: 10547

Copperhead™ Carbide Cutters Wall Thickness Guide <- Click to Open

General Mag Drill & Annular Cutter Drilling Tips

#1 cause of broken or prematurely dull cutters is too slow of feed rate. Slower feed
rates will not add life to your cutter but actually reduce the cutter's life. Use firm steady feed pressure throughout cut.

Always make sure to clear all chips from your cutter before starting the next hole.

Make sure support system for drill arbor is in place and not worn out. If using on a drill press, a support system must be used.

For harder material use Hougen's Premium Cutters or Copperhead Carbide Tip Cutters.

Make sure mag drill is on a clean work piece and securely attached. Uneven or large build up of debris can cause drill slippage.

Material must be at least 3/8" thick. Painted material can also be troublesome if

paint buildup does not allow magnet to hold securely.

When slug ejection becomes unreliable or tool resists cutting, resharpen or replace your cutter.

Always use coolant when drilling. For best results use Hougen's Slick-Stik^TM or RotaMagic^TM cutting lubrication.

For best performance always maintain your drill as instructed in your operator's manual.

Always observe standard and specific safety instructions.

When in doubt, call M&R Machine & Tool (630) 351-2810.